water flow meter adjustable pulse output


Feb 21, 2017 · testing pulse-output from water meter post by ngant17 » august 18th, 2016, 2:14 pm i seem to have lost my water flow data from my irrigation system which as an ekm 1in. pulse-output water meter.
When it comes to water meters, a pulse output is simple spst (single pole, single throw) dry contact reed switch. the switch is normally open. the switch closes when a magnet is in close enough proximity to pull the reed to the closed position. the magnet is positioned on a dial (or drum in some cases) that rotates due to water flow.

A wide variety of water flow meter pulse output options are available to you, there are 3,896 water flow meter pulse output suppliers, mainly located in asia. the top supplying countries are china (mainland), hong kong, and singapore, which supply 98%, 1%, and 1% of water flow meter pulse output respectively.


If you need additional information, or have any special requests for equipment, please fill out the following form.




  • Testing pulse-output from water meterekm metering

    Feb 21, 2017 · testing pulse-output from water meter post by ngant17 » august 18th, 2016, 2:14 pm i seem to have lost my water flow data from my irrigation system which as an ekm 1in. pulse-output water meter.

  • Pulse output water flow sensorfrequency counter ...

    The sensor outputs a square signal which frequency is proportional to the water flow going through the sensor. the pulses are not proportional to a specific amount of water, so pulses can not be counted to obtain a final amount of water. the frequency and the flow rate are related on the equation freq = (gpm/k)offset.

  • Water meters for totalization and rate indication with ...

    Water meters for totalization and rate indication with pulse output flow rates from 0.22 to 132 gpm 150 psi maximum operating pressure do not require power. basic40°c (105°f) maximum operating temperature field-adjustable pulse output (optional) the ftb8000b series meters use the multi-jet principle, which has been an internationally accepted

  • Introduction to pulse counting archived forum

    Wired / switched output supply voltage. meters often have a fairly wide pulse output supply voltage range of 3 to 35v. so the 5v supply from an arduino could be used. higher voltages are desirable when there is more noise in the environment and the cable runs are longer.

  • Water meters with pulse outputassured automation

    When it comes to water meters, a pulse output is simple spst (single pole, single throw) dry contact reed switch. the switch is normally open. the switch closes when a magnet is in close enough proximity to pull the reed to the closed position. the magnet is positioned on a dial (or drum in some cases) that rotates due to water flow.

  • Pulse water flow meter, pulse water flow meter suppliers ...

    A wide variety of pulse water flow meter options are available to you, such as free samples, paid samples. there are 11,501 pulse water flow meter suppliers, mainly located in asia. the top supplying countries are china (mainland), turkey, and hong kong, which supply 99%, 1%, and 1% of pulse water flow meter respectively.

  • Water meters (pulse output)daecontrols

    Water meter with pulse output datasheet, as series amr modules the amr is a module specially designed for applications where the pulse output of water meters need to be incorporated into a modbus/rs485 network for creating cost effective data acquisition and auto metering solutions.

  • Water flow meters products for sale ebay

    G1" water flow hall effect sensor switch flow meter flowmeter counter 1-60l/min output waveform: square wave, output pulse signal. flow range: 1-60l/min. waterproof, heat resistance, pressure resistance, cold resistance.

  • Pulse instrumentsinstruments, meters and controlsflow

    The digital flow meter is wall mounted with a digital readout of the flow rate, a resettable totalizer, and a permanent totalizer. it has two relays for alarm or contact control, analog and pulse output. the pulse output may be configured to send a selectable number of pulses per gallon.

  • Water metering

    Water meters can also be used at the water source, well, or throughout a water system to determine flow through a particular portion of the system. in most of the world water meters measure flow in cubic metres (m 3 ) or litres [1] but in the usa and some other countries water meters are calibrated in cubic feet (ft. 3 ) or us gallons on a mechanical or electronic register.

  • Water flow metercoulton

    Water flow meter installation and operating instructions ® 3 ... d. output <4-20 ma, pulse> e. full flow f. flow cutoff g. response 7. totalizer reset the flow totalizer can be reset to zero

  • Pulsed water meters for monitoring and measuring water usage

    These meters give a pulse output (usually from a magnetic reed switch) for a fixed volume of water flowing through them. the k factor as it is known is the number of litres per pulse output. on smaller meters from 1/2” to 1 1/4” bsp, the factor is usually 1 litre per pulse. this increase to 10 litres per pulse and 100 litres per pulse for the larger sizes. our wlds-10 mk3 and wlds-20 mk3 leak detection …

  • Hot water meters for totalization and rate indication with ...

    Hot water meters for totalization and rate indication with pulse output u flow rates from 0.22 to 132 gpm u 150 psi maximum operating pressure u 90°c (194°f) maximum operating temperature u field-adjustable pulse output (optional) the ftb8000hw series meters use the multi-jet principle, which has been an internationally accepted

  • Liquid flow meter with pulse output : calibrating the water

    Liquid flow meter with pulse output : calibrating the water & water-based chemicals. the flow meter is a device to measure the quantity and the volume of the fluid flowing through a conduit. depending on the factors like flow meter material, nature of fluid flowing, and its application, the flow meters are divided into various categories.

  • Flow sensormidwest instruments & controlswater flow ...

    Flow meters. pulse output flow sensor, when used in conjunction with the appropriate adapter, can monitor flows in pipes ranging in size from ½” to 8”. paddle wheel flow meters are universally accepted as a means of measuring flow electronically. wide range in flow rates, negligible head-loss and good accuracy at a reasonable price continue...

  • Water flow meter pulse output, water flow meter pulse ...

    A wide variety of water flow meter pulse output options are available to you, there are 3,896 water flow meter pulse output suppliers, mainly located in asia. the top supplying countries are china (mainland), hong kong, and singapore, which supply 98%, 1%, and 1% of water flow meter pulse output respectively.

  • Digital pulse counter for water meters with pulse output

    The kal-d06 digital pulse counters are small, lithium battery powered, totalizing counters that are panel mounted. they use the latest custom cmos technology and incorporate an 8 digit, 0.354” (9mm) high, lcd display. it operates from a long life lithium battery (10 years) and can be operated from contact closure or high speed electronic devices.

  • Series wmt2 multi-jet water meter with pulsed output is ...

    The series wmt2 multi-jet water meter is a series of mechanical, water totalizing meters that display the total water usage in gallons or m3 and provide a reed switch output proportional to flow rate. they are available in a range of body sizes and include npt or bspt couplings. not for potable water use, brass contains lead in excess of low lead limits.